Table of Contents
Advertisement
Available languages
Available languages
If...
Temperature of hot
water is low.
The temperature
indication goes up and
down itself.
The energy saving
function is not
activated or canceled.
The unit start boiling
suddenly.
The unit looks like
power is off.
The healthy tea function is
canceled.
Lamp flashes while buzzer
sounds
(Power supply stops)
pi pi pi pi
Flashes alternatively
Boiling without water will cause odor and change the color of fluorine resin.
Possible cause
The keep-warm temperature will
drop when the energy saving
function by turning off the heater.
(It drops to a minimum of 60 ºC.)
When the dispensing time is getting close, it starts boiling
automatically.
When the time is changed to use the hot water, the unit update
the new time and it makes boiling time change. (The boiling time
is updated based on the new memory.)
When the unit is plugged in initial use, this function is not
activating without having memory.
Over 10 hours later after unplug, memory will lose.
Is the energy saving function set?
When
is flashing, other button
is pressed.
When
lights on, water is
added.
Overheating protection
To prevent overheating, this is
activated when it boils without
water.
Is water filled higher than
minimum water level mark?
Is the lid left opened when
water is filled ?
It may light on:
when hot water is filled.
depending on method of filling
water.
Is citric acid settled at the
bottom of inner container while
citric acid washing ?
How to fix
Reboil again.
Light on
Release the energy saving
function.
Press
button.
Fill the water higher than
minimum water level
mark, close the lid and
press
.
Press
.
Once disconnect the
power plug, mix with
chopsticks and wash after
citric acid is distributed.
See
page
EN7
EN9
—
EN9
EN9
—
—
EN12
EN14
Advertisement
Table of Contents
