Panasonic NC-SSA400 Operating Instructions Manual page 13

Once every two or three months to clear scale.
How to clean with citric acid
1
Make sure that the mesh filter is attached to the inner container.
2
Put citric acid in the inner container.
Amount of citric acid to be used at one time:
80 g (two packages) or seven level tablespoons.
For citric acid, please contact an authorized service center (as described in the
warranty). (Model No: SAN-80N)
* Follow the directions for cleaning printed on the citric acid package.
* Since the citric acid used for cleaning is a food additive, it is harmless to humans.
3
Add water to the maximum water level mark,
and mix the citric acid and water well. Close the
lid.
4
Connect the power plug, and choose "Cleaning" by pressing
Cleaning start
Light on
Light off
It rotates during cleaning.
5
Dispense some water, then unplug, remove the lid and drain away the hot water via
the mark. (õ. EN7)
DRAIN
6
Refill with water and boil it to remove the smell of the citric acid.
Then throw the hot water away in the same way as step 5.
To remove any discoloration from the area above the maximum water level, rub the inside lightly
with a wet soft sponge.
If the discoloration cannot be removed by rubbing, clean the inner container several times using citric acid.
When washed without removing ceramic filter, wash the ceramic filter under running water and fix
it in the inner container. Boil water and drain away.
Requests
Make sure only use citric acid for thermo pot washing.
Do not fill water above maximum water level.
Fill the inner container only with tap water (do not fill with hot water). Hot water may spout out
causing burns.
End of cleaning
Light off
Citric acid
.
peep peep
peep peep
Flashing
simultaneously
EN12