Care & Cleaning - Panasonic NC-SSA400 Operating Instructions Manual

Care & Cleaning
(Before cleaning, be sure to disconnect the power plug from outlet, dispense water and cool down the unit.)
Main unit and lid
Clean with a damp, well-wrung cloth.
Do not wet or soak the main unit in water.
(
If water enters the main unit from the bottom or
from the dispensing spout, it can also get into
the electrical components in the main unit and
may cause a malfunction.
Do not use detergents. (They may leave an odor.)
Do not use benzine or thinner. (They may damage the surface.)
Inner container
Clean with a wet soft sponge.
Do not use polishing
powder, a scrub brush or a
nylon brush.
They may damage the fluororesin finish
(
of the inner container.
About "Scale"
While you are using this unit, minerals
contained in the water (like calcium) can get
stuck on the inner container or on the mesh
filter. This is called "scale", and it is harmless.
Milky-white gritty surface (caused by calcium)
White or glittering floating material
(crystals of minerals)
Discoloration in the finish like dark brown,
gray, or green areas
(metallic ion made on the fluororesin covering)
These are not discoloration or corrosion of the
inner container itself, nor are they flakes from
the fluororesin covering.
Clean the inner container using citric acid.
(õ. EN12)
Ceramic filter
Shake in water roughly every
few months, and scrub the
surface with soft sponges.
Do not wash with detergent.
(It causes odor remain)
Do not use dishwasher with dryer or dish
dryer. (It causes deformation)
Mesh filter
Clean the filter with a brush.
When filter is clogged, water
does not flow smoothly.
* After cleaning the filter, be
sure to reattach it to the
inner container.
EN11
Daily
Maintenance
)
)
When storing the unit
Dry it thoroughly.
Put it into a plastic bag and seal the bag to
keep insects from getting in.
Clean with
Citric Acid