Panasonic MC-UL426 Operating Instructions Manual page 32

1 3
Motor
Shaft
Belt Groove
Remove beater bar by carefully lifting out.
Remove worn or broken belt.
Clean beater bar and the end caps (See
BEATER BAR CLEANING, page 35).
1 5
After reinstalling the beater bar, turn by
hand to make sure that belt is not twisted
or pinched and that all rotating parts turn
freely.
1 7
Press lower plate onto nozzle and secure
by rotating the lower plate latches to the
LOCK position.
Lower
Plate
Latches
1 4
End
Cap
Slot
Groove
Loop new belt around motor shaft and
beater bar belt groove; see illustration for
correct belt routing.
Reinstall beater bar back into nozzle
housing grooves.
1 6
Reinstall lower plate. Ensure tabs are
locked into slots.
- 32 -
Beater
Belt
Bar
Nozzle
Tabs