Switching On; Warning: Calibration Requirement; Emc Conformance - Raymarine ST60+ SPEED INSTRUMENT Owner's Handbook Manual

Chapter 3: Installation
To fit a power cable:
1. Ensure the intended power source is switched off.
2. Run the power cable from the instrument to a suitable 12 V dc power source.
12 V dc
supply
Power connections for stand-alone instrument
3. If the cable has not already been trimmed at the power supply end:
i. Cut the cable to length and trim back an appropriate amount of the outer
ii. Cut back and insulate the yellow wire.
4. Connect the screen to the power supply 0 V terminal.
5. Connect the red wire, via a 3 A fuse or protective circuit breaker, to the power
supply +12 V terminal.
6. Insert the power cable connector into one of the SeaTalk connectors at the
rear of the instrument.

3.3 Switching on

Switch on the power to your ST60+ instrument. When the power is on, you can
use the speed button to switch the instrument on and off as described in
Chapter 1, Operation
Use the procedures in
how you want them.

WARNING: Calibration requirement

To ensure this product performs at its best on your boat, you
MUST calibrate it before use, in accordance with the instructions
Chapter 4, Calibration
in
successfully calibrated it.

EMC conformance

Always check the installation before going to sea to make sure that it is not
affected by radio transmissions, engine starting etc.
3 A over-current
circuit breaker
sheath.
.
Chapter 1, Operation
Red
Screen
to set the backlighting and contrast
Do NOT use the product until you have
.
23
D4310-7