Major Messages And Actions; Warning Messages - Konica Minolta bizhub C3100P User Manual

4.4

Major messages and actions

4.4 Major messages and actions
Check the displayed message, then take the appropriate action. If messages other than those listed below
have been displayed, follow them to perform processing.

Warning messages

Message
[UNABLE TO COLLATE JOB]
[HDD NEAR FUL]
[I-UNIT LIFE]
[TONER OUT]
[TRANS. BELT END OF LIFE]
[TRANS. ROLLER END OF
LIFE]
[FUSER UNIT END OF LIFE]
[WASTE TONER NEAR
FULL]
[I-UNIT LOW]
[TONER LOW]
[PAPER EMPTY]
[DEVICE NOT SUPPORTED]
[AUTH TIMEOUT]
[PORT AUTH ACTIVE]
[Maintenance/Troubleshooting]
Description
Because there is insufficient free
space on the HDD, printing on a
set basis is not possible.
The HDD free space is insuffi-
cient.
The operating life of the Imaging
Unit has expired.
Toner is depleted.
The operating life of the Transfer
Belt Unit has expired. Printing is
possible, but the printing quality
is not assured.
The operating life of the Transfer
Roller has expired. Printing is
possible, but the printing quality
is not assured.
The operating life of the Fuser
Unit has expired. Printing is pos-
sible, but the printing quality is
not assured.
The Waste Toner Bottle will be-
come full soon.
The operating life of the Imaging
Unit will expire soon.
The toner is about to run out.
No paper is loaded in the tray.
An incompatible USB device has
been connected to the USB port.
IEEE802.1x authentication has
not been executed normally,
causing a timeout.
IEEE802.1X authentication is
currently executed.
Remedy
Only one copy is printed, and this
function is automatically canceled.
Delete data saved on the HDD, if
necessary.
Replace the Imaging Unit.
For details, refer to page 2-8.
Replace the Toner Cartridge.
For details, refer to page 2-3.
Replace the Transfer Belt Unit.
For details, refer to page 2-17.
Replace the Transfer Roller.
For details, refer to page 2-15.
Replace the Fuser Unit.
For details, refer to page 2-22.
Prepare a new Waste Toner Bottle.
Prepare the specified Imaging Unit.
Prepare the specified Toner Car-
tridge.
Add paper.
Disconnect the USB device.
Restart this machine.
Wait until authentication is complet-
ed.
4
4-8