Setting Remote Control Codes - Yamaha RX-V365 Owner's Manual

Remote control features

Setting remote control codes

You can control other components by setting the
appropriate remote control codes. For a complete list of
available remote control codes, refer to "List of remote
control codes" at the end of this manual.
Remote control code default settings
Input Component
source category
CD CD
MD/CD-R CD-R
TUNER TUNER
DVD DVD
DTV/CBL —
V-AUX TUNER
DVR DVR
A TUNER
B TUNER
C TUNER
D —
E —
Note
• You may not be able to operate your Yamaha component even if a
Yamaha remote control code is preset as listed above. In this case, try
setting another Yamaha remote control code.
1
While pressing and holding one of the input
selector buttons (f) on the remote control to
select the input area you want to set up,
press bAV POWER for more than 3
seconds.
A B C
CD MD/CD-R TUNER
DVD DTV/CBL DVR
D E
V-AUX
While holding down
38
En
Default
Manufacturer
code
Yamaha 5013
Yamaha 5001
Yamaha 5007
Yamaha 2000
— —
Yamaha 5011
Yamaha 2011
Yamaha 5012
Yamaha 5009
Yamaha 5017
— —
— —
POWER
AV
Press for 3 seconds
2
Press the numeric buttons (0 to 9) (y) to
enter the four-digit remote control code for
the component to be used.
When the setting succeeds, "RemoteSetup OK"
appears; however, when it dues not, "RemoteSetup
NG" appears on the front panel display.
Notes
• If the manufacturer of your component has more than one code, try each
of them until you find the correct one.
• If you do not press any buttons within 30 seconds in step 2, the setup
process is canceled. If this happens, repeat the setup procedure.
■
Resetting all remote control codes
Use this feature to clear all the remote control codes
previously set and reset all of them to the initial factory
settings.
1
While pressing and holding hAMP, press
bAV POWER for more than 3 seconds.
AMP
While holding down
2
Press the numeric buttons (y) to enter the
code number "9981."
"RemoteSetup OK" appears on the front panel
display, and the remote control codes previously set
are cleared and reset to the initial factory settings.
y
• If you do not press any buttons within 30 seconds after step 1, the
clearing process is canceled. In this case, repeat the clearing
procedure.
POWER
AV
Press for 3 seconds