Yamaha YSP-2700 Owner's Manual page 95

Problem
No sound or sound is too low. Incorrect input or output cable connections.
No appropriate input source has been selected.
The volume is turned down.
The sound is muted.
There is input signal cannot be played back by this unit.
"HDMI Audio Out" is set to "TV".
"HDMI Control" is set to "Off".
Sound from an HDMI control-enabled TV is set for output from the TV's
built-in speakers.
No sound is coming from the subwoofer.
Sound is intermittent. Audio output methods for surround playback were switched.
No sound or too small sound from The output level of the channel is muted.
a specific channel.
The beam setting is inappropriate.
The source is played in stereo playback mode.
Surround sound effects are When connecting this unit with playback device and TV digitally, the output
insubstantial. setting of the playback device and TV is not valid.
The playback device is set for constant output from 2 channels (PCM, etc.). Change the playback device's audio output setting.
The listening room is not a regular shape, or the unit or listening position is
not at the center of the right and left wall of the listening room.
There is no wall in the path of the sound beam.
When "My Surround" is set to "On", listening position is not in front of the
unit.
Cause
Connect the cable properly.
Select an appropriate input source with the input selector keys.
Turn up the volume.
Press the MUTE (
the volume level.
Play a source whose signals can be reproduced by this unit. Change the
system settings of the source device.
Set to "AMP".
When connecting ARC (Audio Return Channel) supported TV and this unit
using an HDMI cable only, set "HDMI Control" to "On".
To use this unit with "HDMI Control" set to "Off", connect the TV's audio
output jack to this unit's TV (optical digital) input jack via the optical digital
audio cable.
Use the TV's HDMI settings to set audio output to any option other than the
TV's built-in speakers.
Refer to the "No sound is coming from the subwoofer." and "The volume of
the subwoofer is low." problems.
Sound may be intermittent if the CINEMA DSP program is changed.
Raise the output level of the channel.
Adjust the beam setting.
Switch to surround playback mode.
Refer to documentation supplied with your device and check the setting.
Relocate the unit or listening position.
Place the sound reflection board in the path of the sound beam.
Listen in front of this unit.
Remedy
) or VOL (+/-) key to resume audio output and adjust
APPENDIX ➤ Troubleshooting
See page
25
39
39
39
110
80
80
24
–
96
–
43, 77
32, 72
40, 42
–
–
14
103
76
95
En