Table of Contents
Advertisement
INSTALLATION
INSTALLATION
See the separate installation instructions included in the
set of documents.
ELECTRICAL INSTALLATION
Connect the machine by plugging it into an earthed
wall socket. The electrical wall socket must be placed
outside of the installation area to be easily accessible.
WARNING!
The receptacle on the rear of the machine is designed
to accommodate ASKO washers ONLY (rated 208–
240 V.) To use this receptacle, you must use the ready-
fi tted plug supplied with the washing machine or an
equivalent. ASKO washers rated 208–240 V have two
internal fuses of 15 A each. The machine should only
be connected to a grounded wall socket.
WARNING!
This appliance must be properly grounded. Refer
to the "Important Safety Instructions" for grounding
instructions. The power supply cord must be
grounded. If the machine is to be used in a wet area,
the supply must be protected by a residual current
device. Connection to a permanently wired supply
point must be made only by a qualifi ed electrician. As
supplied: Single-phase, 230 V, 60 Hz, 2500W heater
rating 30 A circuit required.
Remove cover to
access teminal box.
(Requires- Torx
screwdriver.)
Customer Care Center, 1-800-898-1879, www.askousa.com
CONNECTION ON DELIVERY
• 208-240 V, 1-phase, 15 A
• 60 Hz
• Use a type A residual-current device.
NOTE!
Do not connect the machine to the mains electricity
supply by an extension lead.
23
Advertisement
Table of Contents
