Cleaning The Auto Fi Lter; Cleaning The Outside Of The Machine - Asko T884HP XLW Operating Instructions Manual

Hide thumbs Also See for T884HP XLW:
Table of Contents

Advertisement

CARE AND CLEANING
5. Remove the sponge fi lter (B) from the fi lter support
(A). Clean it with a vacuum cleaner and wash it under
running water.
A
RECOMMENDATION!
Wash the sponge fi lter in the washing machine after 30
drying cycles (use the rinse or quick wash program).
6. Clean the heat pump ribs by spraying water on them
(use a plant sprayer). The water will carry away the
lint and the condensate pump will drain the lint and
water mixture.
7. Replace the clean sponge fi lter into the fi lter support.
To replace the support, fi rst insert the bottom edge of
the support under an angle, and then lightly press it
towards the heat pump ribs to align it. Close the heat
pump door.
NOTE!
Do not touch the heat pump ribs. They are very thin
an easily damaged. If the ribs are bent or damaged,
the effi ciency of the condenser unit will deteriorate
considerably, which in turn leads to poorer drying
results.
B
Customer Care Center, 1-800-898-1879, www.askousa.com
CLEANING THE AUTO FILTER
Clean the fi lter at the intervals shown on the machine's
display or more often
1. Pull the condensed water container out and up.
2. Unscrew and remove the auto fi lter.
3. Rinse the auto fi lter clean with water.
4. Screw the autofi lter back into place. Check that the
seal is properly seated.
NOTE!
Clean the fi lters after each drying.
Do not replace the fi lters if they are damp or wet.
Damp or wet fi lters could cause operational faults.
NOTE!
The dryer should never be operated without the fi lters
in place, or with damaged fi lters as excessive amount
of accumulated fi bres from the fabric could cause
malfunction or failure of the dryer.
CLEANING THE OUTSIDE OF THE
MACHINE
Clean the outside of the machine and the programme
panel with a mild cleaner. Do not use solvents, as these
can damage the machine. Do not hose down or spray
the machine with water.
NOTE!
Do not allow dust to accumulate around the machine.
Keep the area around the tumble dryer clean and cool;
dust, heat and moisture prolong drying times.
Sealing
17

Advertisement

Table of Contents
loading

Table of Contents