Table of Contents
Advertisement
Available languages
Available languages
STARTUP
Before operating this monitor, confirm that the camera, other video sources and peripherals are connected correctly and securely.
1. Turn on the monitor by pressing the
The power indicator lights up in green.
2. Select the desired input to be displayed by pressing the
SELECT
button.
Onscreen display of the input signal currently on use displays
for approximately 2 seconds on upper left portion of the moni-
tor screen.
Onscreen Display
VIDEO
S-VIDEO
COMPONENT
PC
INPUT SELECT
3. Press the
signal while it is being displayed.
Pressing the button repeatedly displays input in the sequence
shown below. Onscreen display of selected input appears for
approximately 3 seconds.
VIDEO
PC
When input signal is being detected, onscreen display of
PROCESSING
appears on upper left portion of screen and
performs normal video display.
POWER
button.
INPUT
Video Input
VIDEO IN
S-VIDEO IN
COMPONENT IN
PC IN
button to select the desired input
S-VIDEO
COMPONENT
Onscreen display of
NO SIGNAL
screen as shown below, when there is no input signal.
NO SIGNAL
Note:
• During onscreen display of
POWER
(except
button) are disabled. All buttons are
enabled after onscreen display of
disappeared.
Onscreen display of
VIDEO LOSS
screen as shown below, when currently used input is discon-
nected.
VIDEO LOSS
When picture is set to PC input, pressing the
auto tuning of picture size and position.
Onscreen display of
AUTO TUNING
screen as shown below.
AUTO TUNING
Note:
AUTO
• Press the
button, when screen resolution is
changed from the connected PC.
When changing the resolution setting, there are cases
that auto tuning will not be completed.
(Refer to page 19)
displays on the center of the
PROCESSING
, all buttons
PROCESSING
has
displays on the center of the
AUTO
button initiates
displays on the center of the
13
Advertisement
Chapters
Table of Contents
