Installation; Removing Stand In The Monitor; Mounting Into The Rack - Panasonic WV-LC1710 Operating Instructions Manual

INSTALLATION

Cautions:
• The installation described below should be made by qualified service personnel or system installers.
• During installation, remove all connected cables and turn off the power of the monitor.

Removing Stand in the Monitor

Before installing this monitor on the wall or in the rack, the monitor stand shall be removed.
Stand Arm
Mounting Screws
(M4)
Stand Cover
Mounting Screws
(M4)

Mounting into the Rack

To install this monitor in rack, use the Rack Mount Bracket WQ-LM171 (optional) and rack mounting screws (procured locally).
Mounting Screws
(M3×8)
Mounting
Screws
(M4×12)
Rack Mounting Screws
(procured locally)
Mounting Screws
(M4)
Stand
Upper Rack
Mount Bracket
EIA Rack
Mounting
Screws
(M4×12)
Mounting Screws
(M3×8)
Remove two M4 screws to remove the stand cover.
1
Remove the stand assembly by removing four M4
2
screws from the stand.
3 Remove the stand arm by removing the three remaining
M4 screws.
1 Remove four screws on both side panels.
2
Mount the rack mount brackets to the sides of the moni-
tor.
Fix the rack mount brackets by using four supplied
screws (M4×12).
3
Mount the upper rack mount bracket on the upper side
of the monitor.
Fix the upper rack mount bracket by using two supplied
screws (M3×8).
4
Install securely the monitor in the rack using eight
screws (procured locally).
9