Wiring; Terminal Strip Overview - Bosch ISC-FPB1-W60QS Installation And Operation Manual

Photobeam 5000
4

Wiring

Refer to Terminal strip below for transmitter/receiver terminal locations. Use duct
pipes for outdoor wiring. Do not use aerial wiring.
Caution!
Only apply power after all electrical connections are completed and inspected.
!
Notice!
Tamper and EDC terminals should be connected to a 24-hour supervisory loop
Notice!
Power is to be provided by a UL Listed burglar alarm power supply or burglar alarm control
panel. In case of power failure, the power supply or control unit shall have a minimum of 4
hours of standby power.
Notice!
All wiring is to be in accordance with the National Electric Code, ANSI/NFPA 70
Notice!
This system should be tested at least once a week to ensure proper function.
4.1

Terminal strip overview

Figure 4.1: Terminal strip component overview
Callout ﹘ Description
1 ー Receiver
2 ー Transmitter
3 ー Power (non-polarized)
Bosch Security Systems, Inc.
1
3
4 6 5
Installation and Operation Guide
2
3
4
Callout ﹘ Description
4 ー Tamper
5 ー Alarm output
6 ー EDC output
Wiring | en 13
2016.02 | 03 | F.01U.305.910