Electronic Controls - Westinghouse WRB3504S User Manual

ELECTRONIC CONTROLS

All functions and controls of the unit are accessible from
a control panel conveniently located on the roof of the
cabinet. A display circuit board allows easy configuration
of features and settings in a simple and intuitive manner.
IMPORTANT TIPS & INFORMATION
When the refrigerator is energized, all the pilot lights will
turn on for 3 sec and you will also hear a long "beep".
The display board consists of four buttons and eight pilot
lights. You will hear a short "beep" when you press the
button. The electronic controls are located on the inside
top section of the cabinet.
The display panel consists of four buttons and eight
display lights. When the refrigerator is turned on all
the display lights will turn on for 3 seconds and the
refrigerator will emit a long "beep". A short sound of
"beep" will subsequently be heard when pressing any
of the buttons after initial start-up.
On/Hold for Off
Start the refrigerator by pressing the On button. To turn
the refrigerator off, press and hold the On button. Pressing
the On button after the refrigerator has been turned off
will return the refrigerator to it's previous setting.
Controlling the temperature
We recommend that when you start your refrigerator for
the first time, the temperature for the refrigerator is set
to 3°C. If you want to change the temperature, follow the
instructions below. Make only small adjustments and wait
24 hours to see if it's correct.
Checking the coldness of water kept in the refrigerator
is a good way of checking the temperature of the food
compartment.
NOTE: When you set a temperature, you set an average
temperature for the whole refrigerator cabinet.
Temperatures inside each compartment may vary,
depending on how much food you store and where you
place it. High or low room temperature may also affect
the actual temperature inside the refrigerator.
If no button has been pressed for some time there
may be a delay of up to 2 seconds before the display
responds, this is normal and is a part of the display design
to reduce the chance of accidental changes.
To set the fridge temperature, press the Temp button
until the desired temperature between 8°C and 2°C is
illuminated. The light of the corresponding temperature
will be lit corresponding values according to the
following sequence.
Quick Chill
Use the Quick Chill function when you add a large
amount of food to the refrigerator or you need to chill
food or drinks quickly. To use this function, press the
Quick Chill button once. The button will light up and the
fridge temperature indicator will display 2°C.
Quick Chill will automatically switch off after 6 hours.
You can switch the Quick Chill function off manually by
pressing the Quick Chill or Temp button once.
Door alarm
If the refrigerator door is left open for longer than 2
minutes, a buzzer will sound The buzzer will beep 3 times
per minute for 10 minutes. Closing the door cancels the
door alarm.
To save energy, please avoid keeping the door open for a
long time when using the refrigerator.
Alarm Reset
If the alarm sounds, the Alarm Reset icon will light up and
a buzzing sound will start. Press the Alarm Reset button
to stop the alarm.
ELECTRONIC CONTROLS
11