Panasonic CS-20KM1HPK Installation Manual page 6

Installation
panel
(3) Make a through hole in the wall.
• Piping can be led out from the left, right or rear sides.
• The drain hole is on the right side. Installing the unit with a slight drop to the right will allow drainage to
flow smoothly.
• Select the piping route and open a through hole in the wall (φ80). Ensure the hole slopes gradually down-
ward to the outside.
(4) Hang the indoor unit securely from the hock on the installation panel as shown at below.
• Install the unit flat against the panel and not leaning forward.
• Do not hold the indoor unit by the horizontal flaps when lifting. This may damage the flaps or bushing.
(5) If running pipes from the left side or using embedded pipes, remove the bottom panel to make work easier.
(6) How to detach side and bottom panels
• Remove the screws in the side panel and pull the side panel outward (A). Then, while pushing upwards
(B), slide the panel towards the front of the unit (C). (Same for both left and right sides)
• After detaching the side panels, turn the bottom panel downward (D) about 45°, and pull it outward (E).
Hole where to hook
indoor unit
Wall
Installation panel
Hook
5
Screws
Left side
panel
Side panel screw
Left side
panel
Cut an opening in the left or
right side panel for piping.
Ex.: For right side piping
Cutting possible up
to this point.
(C)
Bottom panel
(Top side)
connections
Cut along
perforated
line.
Right
side
panel
Wall
(B)
(A)
(E)
(D)
Approx. 45˚
(A)
Right side panel
(C)
English