Selecting Installation Site; Indoor Unit Installation - Panasonic CS-20KM1HPK Installation Manual

2-4 NOTE TO INSTALLER
• Read this manual carefully to ensure correct installation. Be sure to instruct the customer how to operate
the system showing him/her the enclosed operation manual.
• Explain to the customer what system is installed on the site and be sure to fill in what is required in the col-
umn shown on "WHAT TO DO BEFORE OPERATION" of the operation manual.

3. SELECTING INSTALLATION SITE

(1) Select an installation site where the following
conditions are satisfied and that meets with your
customer's approval.
• Where the wall is strong enough to bear the indoor
unit weight.
• Where sufficient clearance for installation and
maintenance can be ensured.
• Where optimum air distribution can be ensured.
• Where nothing blocks the air passage.
• Where condensate can be properly drained.
• Where not exposed to combustible gases.
• Where piping between indoor and outdoor units is
possible within the allowable limit (Refer to the
installation manual of the outdoor unit.)
• Keep the indoor and outdoor units, power cable and transmission wiring, at least 1 m from TVs and
radios, to prevent distorted pictures and static. (Depending on the type and source of the electrical
waves, static may be heard even when more than 1 m away.)
• Install the indoor unit no less than 2.5m above the floor. Where unavoidably lower, take what measures
are necessary to keep hands out of the air inlet.
(2) Use the installation mount for installation. Check whether the wall is strong enough to bear the weight of
the unit or not. It there is a risk, reinforce the wall before installing the unit.
(The paper pattern for installation is marked for installation pitch. Hold the pattern to the wall to pinpoint
where the wall needs to be reinforced.)
(3) The indoor unit may not be directly installed on the wall. Use the attached installation panel before install-
ing the unit.

4. INDOOR UNIT INSTALLATION

(1) Detach the installation panel from the indoor unit.
• The installation panel is attached to the rear of the unit. To detach, remove the screws from the bottom
of the panel.
(2) Attach the installation panel to the wall, using the paper pattern for installation.
• If using the attached wood screws, fix 4 screws to each the left and right sides (total of 8 or more).
• If using bolts, attach 2 M8 bolts to each the left and right sides (total of 4).
• If installing the unit on a concrete wall, attach the panel with a field supplied anchor (M8).
• Keep approximately 50 mm between the ceiling and the unit.
English
50 or
more
2500 or
more
50 or
more
50 or
more
Required space
4