Transport; Installation - Siemens SISTORE AX4 Lite 1000/100 Configuration & Operation Manual

Safety
1.2.1

Transport

1.2.2

Installation

8
Siemens AG
Damage during transport
z
Keep the packaging material for future transportation.
z
Do not expose the device to mechanical vibrations or shocks.
Damage due to unsuitable mounting location
z
The environmental conditions recommended by the manufacturer must be
observed (see Section 3: Technical data).
z
Do not operate the device close to sources of powerful electromagnetic radiation.
z
Do not operate the device in dusty places.
z
The device should only be used for indoor applications.
z
Do not expose the device to mechanical vibrations or shocks.
z
Protect the device against moisture.
Cable damage due to mechanical load
z
Make sure that cables are not under stress, kinked or damaged.
Damage to the device due to lack of ventilation
z
Do not block or cover the ventilation openings of the device.
z
Do not stack several devices on top of each other and do not place any objects on
the device.
z
Place this equipment only in an upright position. This equipment has an open-
frame Switching Mode Power Supply (SMPS), which can cause a fire or electric
shock if anything is inserted through the ventilation holes on the side of the
equipment.
Danger of electrical shock due to incorrect connection
z
Use the device only in conjunction with a power supply cable that has been
approved in your country and complies with the national standards.
z
This product is designed for TN power systems and for IT power systems in
Norway with 230 V phase-to-phase voltage. Do not connect the device to any
other IT power systems.
Damage to the device due to overvoltage
z
Connect the device only to power sources with the specified voltage. Voltage
supply requirements can be found on the type label (see Section 3: Technical
data).
06.2010