Advertisement
Configuring Engraving Cutters
Place a flat plate under the nosecone and insert
NOTES:
the cutter until it touches the plate.
Tighten the cutter to the brass knob. This will zero
the cutter for the proper cut depth for the
Raster
TM
Braille.
Remove the brass cutter knob and cutter from the
spindle as one piece. Do not loosen the cutter
from the brass knob.
Rotate the nosecone counter clockwise 9 clicks
which will adjust the depth to 0.033" for the
pictogram / raised text cutter.
Insert the character cutter and brass knob onto
the spindle and again place a flat plate under the
nosecone and insert the cutter until it touches the
plate.
Tighten the cutter to the brass knob. This will zero
the cutter for the proper cut depth for cutting the
pictograms and raised text.
Advertisement
