Engravelab Configuration For Ada/Braille Signage - Roland EGX-400 Setup Manual

EngraveLab Configuration for
ADA/Braille Signage.
Launch EngraveLab.
Setup Braille job in accordance with ADA Laws, guidelines and
regulations. Please refer to software documentation for generating
Braille data.
Click on Engrave and Engraving Defaults to configure the driver for the
Braille drill.
Select the driver, set tool for Braille, uncheck Output Tool Paths and
click Apply.
Click on Tool options and set Cut Velocity to 3.9"/sec., Plunge Velocity
to 0.3937"/sec. and Clearance Height to .125" and click OK.
Click Close on the Output window.
Install Braille cutter and configure engraver for the Braille drill.
Select the Braille component and click Engrave, Output and click on
the Engrave icon to output the Raster Braille.
TM