Audiovox CCS-100 Installation Manual page 6

UNDER HOOD INSTALLATION
Connecting the Cruise Control Cable to the Throttle
NOTE: Prior to attaching servo cable to throttle, locate an accessible area to mount the cruise control servo,
but do not mount it. Leave the servo in this area (unmounted) and route cable to throttle attachment area.
CAUTION: Attach the cruise control cable so that it parallels the existing throttle cable as nearly as possible.
Choose a mounting method from the figures below:
FIG. 1
The bead chain and servo cable end must be
inserted into the bead chain connector. Then the
bead chain coupling sleeve must slide over
bead chain connector to insure that the end will
not hang in the connector.
Determine a suitable point on the throttle linkage to mount the cable connector. The mounting point chosen should have between
1-1/2" to 2" total linkage travel. It must operate smoothly by hand. There should be at least 5 beads between the throttle connector and
servo cable end. The cable must pull in a straight line from throttle linkage. Some vehicles that do not have enough total linkage travel
have to be connected at the accelerator pedal.
FIG. 2 SNAP-ON THROTTLE ARM MOUNT
Existing Snap-On Throttle Arm On Vehicle
Carburetor
Pull off Throttle Arm and Insert Bead Chain Connector between it
and Carburetor Arm. Be sure additional thickness of adaptor does
not bind linkage.
WIRE LOOP FOR PULLEY
FIG. 4
Throttle Wire Loop
(#29)
Throttle Cable
FIG. 6
3 BEAD CONNECTOR
Double fold to shorten
3 Bead Connector
(#27)
Bend to clear Throttle Cable
Throttle Arm
Bead Chain Eyelet
Connector (#25)
Rubber Ring
Crimp with pliers
Throttle Clip
(#26)
Throttle Cable
Bead Chain
Coupling Sleeve (#23)
Bead Chain Coupling (#24)
FIG. 3
CLAMP-ON THROTTLE ARM MOUNT
FIG. 5 WIRE BARREL FOR PULLEY
Barrel Wire Adaptor
(#30)
FIG. 7
FORD LINKAGE ADAPTOR
Cotter Pin (#21) locks Bead
Chain to Linkage Adaptor
Bead Chain
(#20)
-4-
Attachment area for
securing cable
Cable
Cable Must Be within 20° of
same angle as Throttle Rod
20°
Bead Chain Eyelet
Connector (#25)
Snap-on Throttle Adaptor (#22)