Ait Flow - Viking DCH3042 Service Manual

The air drawn in through the filters is regulated back into the kitchen through a top vent that
runs the length of the hood as shown in FIG 7.
In FIG 8, the blower motor assembly has been rotated 180° for rear and top external
discharge. There are (2) 5/16th nuts that secure the blower assembly to the hood housing.
The insets below show each side where the nut is located (circled in red). The right one is
just above the main power connection
©2012 Viking Preferred Service
FIG. 7
FIG. 8
General Information
7