General Information
When the hood is installed to operate in recirculation mode, the addition of charcoal filters
(supplied in kit) is required. FIG 4 shows the standard filter used when the hood is installed
for exterior discharge.
Standard Filter – Exterior Discharge
The charcoal filter is held in place with four securing clips (Included with charcoal filter) as
shown in FIG 5 above.
Remove filters to access the internal blower motors. FIG 6 shows that the motor assembly
consists of two motors, one which rotates in a Cloc kwise rotation (Below right) and the other
in a counter-clockwise rotation (Below left). Each motor is connected separately to the control
housing by the use of a 4-wire Molex disconnect plug (Inset).
Recirculation installation shown
6
FIG. 4
Recirculation – Charcoal Filter Added
FIG. 6
FIG. 5
©2012 Viking Preferred Service