Table of Contents
Advertisement
ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Note: The treadmill walking deck is coated with
high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the
walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there
is lubricant on top of the walking belt, wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires a phillips screwdriver
(not included), as well as the included allen wrench
During assembly, refer to the drawing below to identify the small parts used in assembly.
Handrail Washer (16)Ð2
1. With the help of a second person, carefully lay the
treadmill on its right side as shown (refer to the drawing
on page 4 to identify the right side).
Insert the Extension Legs (41) into the treadmill. Make
sure that the Extension Legs are turned so the Base
Pads (36) are on the indicated side. Attach each
Extension Leg with an Extension Leg Screw (34).
With the help of a second person, carefully raise the
treadmill to the upright position so the Extension Legs
(41) are resting flat on the floor.
Refer to the inset drawing. Remove the nut, bolt, and
shipping bracket from the left Upright (14) and discard
them.
Extension Leg Screw (34)Ð4
, an adjustable wrench
.
Handrail Screw
(4)Ð4
Handrail Bolt (15)Ð2
1
41
36
41
36
, and scissors
Latch Screw (13)Ð2
34
Shipping
Bolt
Bracket
34
Nut
14
5
Advertisement
Table of Contents
