Small Children; Demagnetization; Electrostatic Discharge (Esd); Antenna - Zte MTAG 281 User Manual

Table of Contents

Advertisement

Do not paint your phone or its accessories.
Do not attempt to disassemble your phone or its accessories, only authorized
personnel must do so.
Do not expose your phone or its accessories to extreme temperatures, minimum
- [5] and maximum + [50] degrees Celsius.
Please check local regulations for disposal of electronic products.
Do not carry your phone in your back pocket as it could break when you sit down.

Small Children

Do not leave your phone and its accessories within the reach of small children or al-
low them to play with it.
They could hurt themselves or others, or could accidentally damage the phone.
Your phone contains small parts with sharp edges that may cause an injury or may
become detached and create a choking hazard.

Demagnetization

To avoid the risk of demagnetization, do not allow electronic devices or magnetic me-
dia close to your phone for a long time.

Electrostatic Discharge (ESD)

Do not touch the UIM card's metal connectors.
18

Antenna

Do not touch the antenna unnecessarily.

Specific Absorption Rate (SAR)

Your mobile device is a radio transmitter and receiver. It is designed not to exceed the
limits for exposure to radio waves recommended by international guidelines. These
guidelines were developed by the independent scientific organization ICNIRP and
include safety margins designed to assure the protection of all persons, regardless of
age and health.
The guidelines use a unit of measurement known as Specific Absorption Rate, or
SAR. The SAR limit for mobile devices is 2 W/kg and the highest SAR value for this
device when tested at the ear was 0.862 W/kg*. As mobile devices offer a range of
functions, they can be used in other positions, such as on the body as described in
this user guide**.
As SAR is measured utilizing the device's highest transmitting power, the actual SAR
of this device while operating is typically below that indicated above. This is due to au-
tomatic changes to the power level of the device to ensure it only uses the minimum
power required to communicate with the network.
* Please see body-worn operation.
19

Advertisement

Table of Contents
loading

Table of Contents