Page 2
Google and Android are trademarks of Google, Inc. ® The Bluetooth trademark and logos are owned by the Bluetooth SIG, Inc. and any use of such trademarks by ZTE Corporation is under license. microSDXC Logo is a trademark of SD-3C, LLC. ®...
Getting to Know Your Phone Auxiliary microphone Headset jack Proximity & light sensor Front camera Indicator light Earpiece microSDXC /nano-SIM card slot Power key Touch screen Volume key Ring/Silent switch...
Page 4
Back camera Flash Main Speaker microphone Charging/ micro-USB jack...
Setting up Your Phone Power off your phone before removing or replacing the battery. Power off your phone before installing or removing the nano-SIM card. The microSDXC card can be installed or removed while the phone is turned on, but you need to unmount it before removing it.
Page 6
Pull out the nano-SIM card tray or microSDXC card tray and place the nano-SIM card or microSDXC card on the tray, as shown. Then carefully install the tray back. microSDXC card is not included in the package and is sold separately.
Charging the Phone Your phone’s battery should have enough power for the phone to turn on, find a signal, and make a few calls. You should fully charge the battery as soon as possible. NOTE: If the battery is extremely low, you may be unable to power on the phone even when it is being charged.
Product Safety Information Don’t make or receive phone calls while driving. Never text while driving. The device could be used with a separation distance of 5 mm to the human body. Small parts may cause choking. Your phone can produce a loud sound. To prevent possible hearing damage, do not listen at high volume levels for long periods.
Page 9
Do not expose your device to extreme temperatures lower than – 10 °C and higher than + 55 °C. Hereby, ZTE Corporation declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU.
For this product’s recycling information based on WEEE directive, please send an e-mail to weee@zte.com.cn EC DECLARATION OF CONFORMITY Hereby, ZTE Corporation declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU.
FCC Regulations This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Page 12
FCC RF Exposure Information and Statement The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types: MO-01K (FCC ID: SRQ-MO-01K) has also been tested against this SAR limit. The highest SAR value reported under this standard during product certification for use close to human body is 0.872W/kg, for against the head is...
Page 13
FCC and can be found under the Display Grant section of http://www.fcc.gov/oet/ea/fccid after searching on the FCC ID: SRQ-MO-01K. Enquiring the E-label From the home screen, touch Settings > About phone >...