Replacement Procedures
4.8
Optical disk drive
NOTE: Do not apply excessive force to the top of an optical disk drive.
Removing optical disk drive
The following describes the procedure of removing an optical disk drive (Figure 4-12and 4-
13).
1. Remove the following screws securing an optical disk drive.
2. Disconnect an optical disk drive toward the arrow direction from the connector on
the system board.
3. Take the side screws and disassemble the side bracket
Remove
this screw
Satellite U400/Satellite Pro U400/PORTEGE M800 Maintenance Manual
Downloaded from LpManual.com Manuals
Do not touch the shaded portion of the figure below, when the drive is removed
or installed.
•
M2.0×5.0B
Figure 4-12 Remove optical disk drive
FLAT BIND screw
x1
4-25