Getting Started; Battery Installation - VTech DigiArt User Manual

Step 2:
Unsnap A2, lift the CHALKBOARD/DRY-ERASE BOARD (A) with one
hand and move the back legs forward with the other hand. Insert A2 into
the slot on the back of the SUPPLIES TRAY (B), lining up the hole of A2
with the center screw of the SUPPLIES TRAY (B).
Step 3:
Tighten the center screw by pushing it in and turning it clockwise to fix
it in position.

GETTING STARTED

BATTERY INSTALLATION

1. Make sure the unit is turned OFF.
2. Locate the battery compartment on the
bottom of the chalkboard. Open the battery
cover by sliding the tab.
3. Remove the exhausted batteries and install
4 new "AA" batteries as illustrated.
4. Replace the battery cover and push down
until it clicks into position.
10