Table of Contents
Advertisement
TH51 f OD NON-PROGRAMMABLE
THERMOSTAT
INSTALLER SYSTEM TEST
Use the Installer System Test to test the heating, cooling
and fan.
CAUTION
Equipment
Damage Hazard.
Minimum
compressor
off time is bypassed
during
installer
System Test
Avoid cycling compressor quickly.
How to Use the Installer System Test
1.
Enter the Installer System Test by pressing and
holding down the Up and Down buttons at the
same time for approximately five seconds, until the
screen changes. See Fig. 19.
@ ®
ADVANCES
TO
NEX [
SYSTEM
TEST
NUMBER
M22!4(_
Fig. 20. Review thermostat
buttons
used during
Installer System Test.
Installer System Tests
IMPORTANT
Use the Instafler System Test to test the
heating, cooling and fan. The setting you
choose for System Type (Instafler Setup
Number 1) may prevent some System Test
Numbers from appeanng.
Fig. 19. Enter Installer
System Test.
See Fig. 20 to review how the thermostat buttons
are used during the Installer System Test. See
Table 4 for available Installer System Tests.
Table 4. Installer
System Tests.
System Test Number
Test Type
System Status Number
and Description
10
Heating System Test
1--Heat turns on. When installer Setup Number
1 is set to 1 or Installer Setup Number 3 is set to
1, the fan turns on immediately.
0--Heat and fan turns off.
30
Cooling System Test
1--Compressor
and fan turns on.
0--Compressor
and fan turns off.
40
Fan System Test
1--Fan
turns on.
0--Fan
turns off.
70
Thermostat
information
71--Software
revision number (Major)
(For reference only)
72--Software
revision number (Minor)
73--Configuration
identification code (Major)
74--Configuration
identification code (Minor)
75--Production
configuration date code (Week)
76--Production
configuration date code (Year)
Press the Next button
to go to the beginning
of the Installer System Test or press the Done button to exit the
installer
System Test.
9
69-1712--I
Hide quick links:
Advertisement
Table of Contents
