FocusPRO TH5000 Series Table of contents About your new thermostat Appendices Thermostat features ........2 Battery replacement ........ 10 Setup at a glance ........3 In case of difficulty........11 Quick reference to controls ....... 4 Customer assistance ....... 13 Quick reference to display ......
Operating Manual About your new thermostat Congratulations on the purchase of your new Honeywell thermostat. It has been designed to give you many years of reliable service and easy-to-use, push-button climate control. Features • One-touch temperature control. • Large, clear, backlit display is easy to read—even in the dark.
FocusPRO TH5000 Series This thermostat is ready to go! Your new thermostat is pre-programmed by the installer and ready to use. Just check the settings below and change if needed: Fan (Auto/On): Preset to Auto .........To change, see page 6. Auto is the most commonly used setting, but you may prefer On for improved air circulation.
Operating Manual Quick reference to controls Digital display (see page 5) Battery holder (see page 10) Temperature Buttons Press to set preferred temperature. Function Buttons Press to select the function displayed just above each button. (Functions change depending on the task.)
FocusPRO TH5000 Series Quick reference to display screen Low battery warning (see page 10) Auxiliary heat (Only for heat pumps with auxiliary heat) Temperature Heat Replace Inside Setting setting Battery Current inside temperature Auxiliary Heat On System status System Fan setting Auto Heat Heat On/Cool On...
Operating Manual Select the fan setting Press the button to select Auto or On. System Auto Heat In “Auto” mode (the most commonly used setting), the fan runs only when the heating or cooling system is on. If set to “On,” the fan runs continuously.
FocusPRO TH5000 Series Select the system setting Press the button to select: System Auto Heat • Heat: Thermostat controls only the heating system. • Cool: Thermostat controls only the cooling system. System • Off: Heating and cooling systems are off. Auto Cool •...
Operating Manual Auto changeover (heat/cool) Auto Changeover is a feature used in climates System where both air conditioning and heating are Auto Auto used on the same day. When the system is set to Auto, the thermostat automatically selects heating or cooling depending on the indoor temperature.
FocusPRO TH5000 Series Built-in compressor protection This feature helps prevent damage to the Cool Inside Setting compressor in your air conditioning or heat pump system. Damage can occur if the compressor is Cool On restarted too soon after shutdown. This fea- ture forces the compressor to wait for a few System Auto...
Operating Manual Battery replacement Batteries are optional (to provide backup Press and pull to remove power) if your thermostat was wired to run on AC power when installed. Replace Batttery Install fresh batteries immediately when the warning begins flashing. The warning flashes about two months before the batteries are depleted.
FocusPRO TH5000 Series In case of difficulty If you have difficulty with your thermostat, please try the following suggestions. Most problems can be corrected quickly and easily. • Check circuit breaker and reset if necessary. Display is blank • Make sure power switch at heating & cooling system is on. •...
Page 14
Operating Manual In case of difficulty Heating or • Press button to set system to Heat. Make sure the temperature cooling system is set higher than the Inside temperature. does not respond • Press button to set system to Cool. Make sure the temperature is set lower than the Inside temperature.
TH5000 Series Customer assistance For assistance with this product, please visit http://yourhome.honeywell.com. Or call Honeywell Customer Care toll-free at 1-800-468-1502. Accessories/replacement parts To order, please call Honeywell Customer Care toll- Model number Date code free at 1-800-468-1502. TH5110D xxxxxxx xxxxxxx Battery holder ......Part No.
Operating Manual 5-year limited warranty Honeywell warrants this product, excluding battery, to be free from defects in the workmanship or materials, under normal use and service, for a period of five (5) years from the date of purchase by the consumer. If at any time during the warranty period the product is determined to be defective or malfunctions, Honeywell shall repair or replace it (at Honeywell’s option).
Page 17
This warranty does not cover removal or reinstallation costs. This warranty shall not apply if it is shown by Honeywell that the defect or malfunction was caused by dam- age which occurred while the product was in the possession of a consumer.
Page 18
This warranty gives you specific legal rights, and you may have other rights which vary from state to state. If you have any questions concerning this warranty, please write Honeywell Customer Relations, 1985 Douglas Dr, Golden Valley, MN 55422 or call 1-800-468-1502. In Canada, write Retail Products ON15-02H, Honeywell Limited/Honeywell Limitée, 35...