Installation; Separate Wallplate From Thermostat; Select Thermostat Location; Install Wallplate (See Fig. 3.) - Honeywell th511od Installation Instructions Manual

Non-programmable
Table of Contents

Advertisement

TH5f10D
NON-PROGRAMMABLE
THERMOSTAT
INSTALLATION
When installing this product...
1.
Read these instructions carefufly. Failure to follow
these instructions can damage the product or
cause a hazardous condition.
2.
Check the ratings given in the instructions and on
the product to make sure the product is suitable for
your application.
3.
Installer must be a trained, experienced
service
technician.
4.
After completing installation, use these instructions
to check out the product operation.
CAUTION
Electrical Hazard.
Can cause electrical shock or equipment
damage.
Disconnect power before beginning installation.
Select Thermostat Location
Select a _ocation for the thermostat about 5ft (1.5m)
above the floor in an area with good air circulation at
average temperature.
See Fig. 1.
YES
FEET
[1 5 METER'S]
l
Fig.
1. Select
thermostat
location.
Do not install the thermostat where it can be affected by:
-- Drafts or dead spots behind doors and in corners.
-- Hot or cold air from ducts.
-- Radiant heat from sun or appliances.
-- Concealed
pipes and chimneys.
-- Unheated (uncooled) areas such as an outside wall
behind the thermostat.
Separate Wallplate from Thermostat
1.
Separate the wallplate from the thermostat.
See
Fig. 2.
THERMOSTAT
Fig.
2. Separate
wallplate
from
thermostat.
Install Wallplate (See Fig. 3.)
Mount the thermostat hofizontafly on the wall:
1.
Pull the wires through the wire hole on the
wallplate.
2.
Position the waIIplate on the wall with the arrow
pointing up. Level the waflplate for appearance
only.
3.
Use a pencil to mark the mounting holes.
4.
Remove the wallplate from the wall and drill
two 3/16-in. holes in the wall (if drywall) as marked.
For firmer material such as plaster, drill two 7/32-in.
holes. Tap the wall anchors (provided) into the
drilled holes until flush with the wall.
5.
Pull the wires through the wire hole on the
wallplate and position the wallplate over the wall
anchors.
6.
insert the mounting screws into the watl anchors
and tighten.
SCREWS (2)
M22!40
Fig.
3. Install
watlplate.
69-1712--1
2

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents