Display Modes And Setting Change Messages - Panasonic AJ-HDC20A P Operating Instructions Manual

Viewfinder screen status displays
Display modes and setting
change messages
The display of messages advising the user of what
changes have been made to the settings and what the
adjustment results are can be turned off for some or
all of the items displayed.
Setting change/adjustment result messages and display modes
Situation in which message is displayed
When the filter selection has been changed
When the gain setting has been changed
When the WHITE BAL switch setting has been
changed
When the OUTPUT/AUTO KNEE switch has
been set to AUTO KNEE or OFF
<Note>
This display is shown for about 3 seconds
immediately after the unit's power has been
switched on.
When the shutter speed/mode setting has been
changed
When the white balance (AWB) has been
adjusted
When the black balance (ABB) has been
adjusted
<Note>
The message displays also depend on the status of
other menu settings. For instance, even when "1 (no
display)" is set as the filter selection, the filter
selection will be displayed when FILTER is set to "ON"
on the VF INDICATOR screen.
Message
Filter: n (n=1, 2, 3, 4), m (m=A, B, C, D)
GAIN: n dB
(n= –3, 0, 3, 6, 9, 12, 15, 18, 21, 24, 27, 30)
WHITE: n (n=ACH, BCH, PRESET)
AUTO KNEE: ON (or OFF)
SS: 1/100 (or 1/120, 1/250, 1/500, 1/1000, 1/2000,
S.SCAN, SUPER V)
Example) AWB: OK
For details, refer to "Adjusting the white balance"
(pages 47 to 50).
Example) ABB: OK
For details, refer to "Adjusting the black balance" (page
51).
43
Display mode
setting
1 2 3
t t t t ± ±
t t t t ± ±
t t t t ± ±
t t ± ± ± ±
t t ± ± ± ±
t t ± ± ± ±
t t ± ± ± ±
± ± : Message is to be displayed.
t t : Message is not to be
displayed.