Adjusting The Audio Input Level - Panasonic AG-DVC30 Operating Instructions Manual

Audio dubbing
$ Listening to sound that has
been dubbed
You can switch between the sound that has
been dubbed and the sound heard during
shooting using the 32K (12bit) AUDIO item
setting on the PLAYBACK FUNCTION
screen. (P73)
ST1:
The sound heard during shooting is played
back.
ST2:
The sound that has been dubbed on a
recording is played back.
MIX:
Both the sound heard during shooting and
that you have dubbed on a recording are
played back at the same time.
$ Performing audio dubbing as
you listen to it
You can monitor the sound by setting "ST2"
while audio dubbing
suspended.
If you use headphones when performing
audio dubbing on a recording using mic
input, you can listen to the sound being
dubbed.
When you perform audio dubbing using line
input (from the audio component connected
to the AV IN/OUT jack), you can listen to the
sound being dubbed through the speakers.
Inputs and audio tracks for recordings
Input
External mic L channel
External mic R channel
INPUT 1 (XLR mic) 2
INPUT 2 (XLR mic) 2
Internal mic L channel
Internal mic R channel
Audio IN/OUT CH1 (L channel)
(white phono jack)
Audio IN/OUT CH2 (R channel)
(red phono jack)
O Which sound is to be recorded during shooting is
automatically determined by the order of priority for the
mic inputs.
O The audio tracks on which dubbed sound is to be
recorded can be changed using the A.DUB INPUT item
on the AV IN/OUT SETUP screen. (P77)
58 (E)
(cont.)
is temporarily
When shooting
CH1
CH2
CH1
CH2 (CH1)
CH1
CH2
__
__
$ Using the counter memory
function to edit dubbed sound
1 First reset the counter memory display at
the position where the audio dubbing is to
end. (P53)
2 Rewind the tape to the position where the
audio dubbing is to start, and start the
dubbing.
3 The tape then stops automatically at the
position on the tape where the counter
memory display was reset.

$ Adjusting the audio input level

Use the procedure described for "Adjusting
the mic input audio level" (P46) to adjust the
audio level of mic input and line input (from
the audio component connected to the AV
IN/OUT jack).
$ Adjusting the audio output
level
Use the procedure described for "Adjusting
the headphone volume" (P47) to adjust the
audio level output from the headphones and
speakers.
When performing audio dubbing
in the 32K (12bit) mode
A. DUB INPUT: A. DUB INPUT:
MIC
CH3
CH4
CH3
CH4 (CH3)
CH3
CH4
__
__
2 You will need the XLR microphone adapter (AG-
MYA30G, option) if you intend to use the XLR
microphone. (P56)
Order of priority
for mic inputs
A_IN
__
High
__
__
__
__
__
Low
CH3
CH4