Using The Auto Document Feeder; Setting The Original; Using The Scanner Glass - Panasonic KX-FLB882CX Operating Instructions Manual

Document Requirements

2.4 Setting the original

2.4.1 Using the scanner glass

1
Open the document cover (1).
2
Place the document FACE DOWN on the scanner
glass (2), aligning the top left of the document with
the corner to which the l mark points.
3
Close the document cover.
Note:
L Confirm that there are no documents in the auto
document feeder.
L Place the original onto the scanner glass gently and
do not press down too firmly to avoid malfunction.
L If the original is a thick book, do not close the
document cover.
L Check that the ink, paste or correction fluid has dried
completely.
L Effective scanning area is as follows:
Effective scanning area
L Shaded area will be scanned.
289 mm
4 mm

2.4.2 Using the auto document feeder

1
2
1
2
Note:
4 mm
208 mm
4 mm
4 mm
Insert the document (up to 40 pages) FACE UP into
the feeder until a single beep is heard.
Adjust the width of the document guides (1) to fit
the actual size of the document.
L Confirm that there are no documents on the scanner
glass.
L Check that ink, paste or correction fluid has dried
completely.
L Remove clips, staples or other fasteners.
L Do not set the following types of documents: (Make a
copy of the document using the scanner glass and
set the copy instead.)
– Chemically treated paper such as carbon or
carbonless duplicating paper
– Electrostatically charged paper
– Badly curled, creased or torn paper
– Paper with a coated surface
– Paper with printing on the opposite side that can
be seen through the other side, such as
newsprint
L The total height of the documents when laid flat,
must be less than 4 mm. If the documents exceed the
capacity of the auto document feeder, they may fall or
cause a jam in the feeder.
L To set a document with a width of less than 210 mm,
we recommend using the scanner glass to copy the
original document onto A4 or letter-sized paper, then
setting the copied document.
L Do not set documents that do not satisfy the
requirements of size and weight. Make a copy of the
document using the scanner glass and set the copy.
L Available document size, document weight and
effective scanning area are as follows:
Minimum document size
128 mm
2. Preparation
1
19