Operation With Common Interface; Inserting The Ca Module; Access Control For Ca Module And Smart Card - Grundig 02 GBH 4719 Manual

02Vision 2 19-2930T DVD_en:Layout 1
CHANNEL SETUP
Auto Tuning
Digital Manual Tuning
Analogue Manual Tuning
Programme Table
Signal Information
CA - Module IRDETO ACCESS
Active Antenna Power On
Select
04.09.2009

OPERATION WITH COMMON INTERFACE

Inserting the CA module

Note:
Switch off the appliance before inserting the CA module in the
»CI« slot.
1 Insert the smart card into the CA module.
2 Insert the CA module with the smart card into the »CI« slot on the
television.
Note:
To see which CA module is in the Common Interface slot, go to
the »CA - Module« submenu.

Access control for CA module and smart card

1
Open the menu with »MENU«.
– The »PICTURE« menu is displayed.
s
2 Select the »CHANNEL SETUP« menu with »
s
s
firm with »OK«.
s
3 Select »CA–Module« with »
confirm.
Notes:
Back
This menu give operating instructions and – after you enter your
Exit
PIN code – access to channels of the PAY-TV provider.
The remaining settings are described in the manuals for your CA
module and smart card.
4 Press »MENU« to finish the settings.
9:03 Uhr Seite 53
r
« or »
q w
« or » « and press »OK« to
e
« and con-
53