Table of Contents
Advertisement
02Vision 2 19-2930T DVD_en:Layout 1
CHANNEL SETUP
Auto Tuning
Digital Manual Tuning
Analogue Manual Tuning
Programme Table
Signal Information
CA - Module
Not Inserted
Active Antenna Power
On
Select
Searching...
GGGGGGGGGGGGGGGG
14%...
161.25 MHz
1 ARD
ATV
2 ZDF
ATV
3 BR3
ATV
4 3 SAT
ATV
Skip
Exit
04.09.2009
SPECIAL SETTINGS
Tuning analogue television stations
This setting is only necessary if you cannot receive any digital stations
and you have not carried out an analogue search during initial setup.
The television station can be set directly or using the search.
Switching the television to analogue channels
1
Open the »INPUT SOURCE« menu by pressing »
2
Select input source »ATV« with »
confirm.
Note:
Additional operations are explained in the following sections.
Re-tuning all analogue television channels
These settings are only necessary if you can not receive any digital
stations or if you want to re-tune all analogue channels.
The analogue television stations are listed in the channel list after the
digital television stations.
Note:
Plug the rooftop antenna cable (for analogue television stations)
into the
1
Open the menu with »MENU«.
– The »PICTURE« menu appears.
s
2
Select the »CHANNEL SETUP« menu with »
s
s
3
Select »Autotuning« with »
s
4
Select »Country Selection« by pressing »
r
»
« or »
Back
5
Select the »Scan Type« with »
r
Exit
Press »
with »OK«.
– The »Searching...« menu appears, and the search for analogue
TV stations begins. This may take several minutes depending
on the number of television stations received.
ATV
Note:
You can stop the search by pressing » «.
9:03 Uhr
------------------------------------------------------------------
q
»ANT
IN« socket on the television.
q
w
« or »
e
« to make the setting.
q
«.
e
« or »
« to select the »ATV« display and start the search
Seite 55
«.
w
« or »
« and press »OK« to
r
e
« or »
«.
« and confirm with »OK«.
q
w
« or »
« and press
55
Advertisement
Table of Contents
