Inserting A Capsule Adaptor - Sunbeam EM7100 Instruction/Recipe Booklet

Inserting a capsule adaptor

1.Choose a Capsule adaptor base which
matches your capsule brand,
eg. Black = Nespresso.
Insert the base into the group handle.
Ensure the bayonets on the underside of
the base, are inserted into the slots on the
handle. Ensure the adaptor base sits flush
in the group handle.
3.Insert your corresponding coffee capsule into
Capsule base. Then take capsule top and
place on top. Using both thumbs, press down
on capsule adaptor top until it pierces the
capsule. The capsule must be pierced prior to
inserting into the espresso machine.
IMPORTANT: • The capsule adaptor base and top must be the same colour. If you use different
colours the machine will not work.
• It is important the top spike/ spikes puncture the surface of the capsule,
otherwise there will be no coffee pour.
Note: The spikes in the adaptors are sharp.
*Capsule trade marks are owned by third parties & are not related to Sunbeam.
(See page 26 for full Trade marks Disclaimer)
12
Figure 1
2.When the base is flush in the group
handle, turn capsule adaptor base about
30° so it does not fall out. This will make
it easier when you're knocking out the used
capsules, after you've made your coffee.
Figure 3
4.Your capsule handle is now ready to be
inserted into the machine group handle.
Figure 2
Figure 4