Installing The Ruby2 Workstation - VeriFone ruby2 Installation Manual

Installing the Ruby2 Workstation

Note:
See "Ruby2 Rear Panel" for port locations.
1. Connect one end of a shielded RS-232 cable to a null modem adapter
and connect the adapter to the serial port on the Thermal Receipt
Printer.
2. Plug the other end of the RS-232 cable into COM4 on the Ruby2
workstation.
3. Plug the printer power cable into the printer with the flat side facing
up.
Note:
4. Connect the other end of the printer power cable to the Printer Power
port on the Ruby2. The connector locks into place.
Caution:
Caution:
5. Connect an Ethernet cable to the Ethernet port on the Ruby2
workstation.
Note:
6. Plug the other end of the Ethernet cable into the router (one to two
Ruby2 workstations) or to the network switch (more than two Ruby2
workstations).
7. Plug the cable from the customer display pole into COM3 on the
Ruby2. The customer display pole height can be adjusted.
8. Plug the cable that extends from the bottom of the cash drawer into
the cash drawer port 1. (For two cash drawers, use cash drawer port 1
and port 2.)
Note:
9. Plug the cable from the power brick into the DC Power port on the
Ruby2.
October 01, 2013
The connector slides down to lock or unlock the cable.
To remove the printer power cable, slide the plastic outer
covering of the connector downward. DO NOT pull the cable
to remove it.
The printer port is not Limited Power Source (LPS)
according to UL 60950-1, clause 2.5. The printer connected
to this port shall comply to clause 4.7 of UL 60950-1 and all
fire enclosure requirements. Please consult VeriFone if in
doubt.
Serial RS-232 cables and Ethernet cables do not have the same
pinouts and are NOT interchangeable.
The opening in the key hole on the cash drawer must be facing
downward to close.
Ruby2 Hardware Installation Guide
11