Electrical Connection - AEG 49190GO-MN User Manual

20 www.aeg.com

5.4 Electrical connection

The electrical connection must be
carried out in accordance with the
current standards and laws in force.
Before connecting check that:
• the system and electrical sockets
amperage is adequate for the
appliance maximum power (see
data label affixed on the back of the
cooker).
• the socket or system has an effective
earth connection in accordance with
current standards and prescriptions
of the law. All responsibility is
disclaimed if this is not complied
with.
• the plug and socket or the multipolar
switch must be accessible after
installation of the appliance.
When connecting to the mains with a
socket:
• Fit to the power cable (if without) a
standardized plug, suitable for the
load which is indicated on the data
label. Connect the wires making sure
they correspond as shown below, and
remember that the earth wire must
be longer than the phase wires:
letter
letter
symbol
• The power cable must be laid so
that no parts of it ever reach a
temperature of 75 °C.
• For connecting do not use, adapters
or shunts as they could cause false
contacts resulting in hazardous
overheating.
When connecting directly to the mains:
• Install a multipolar switch that can
withstand the appliance load, with
a minimum opening between the
contacts of 3 mm. Remember that
the earth wire must not be cut out by
the switch.
Connecting the power cable
The all-electric cookers and some combi
versions are without supply cable and
are adjusted for single-phase power,
butt they can, with due modifications,
be powered by three phase systems by
following these instructions:
L (phase) = brown wire
N (neutral) = blue wire
= green/yellow wire
(earth)
• Remove the rear panel from the
cooker.
• Move the connecting plates in the
terminal board fig.7, following the
diagram in fig. 8.
• You will also find this diagram affixed
to the back of the cooker.(fig.9)
according to the type of connection
you want.
• Connect the power cable, whose
cross section must be suitable
(see paragraph «TECHNICAL
FEATURES»), keeping the earth wire
longer than the phase wires.
• Secure the cable in the clamp and -
fit the rear panel in place.
L
fig.7
L1 L2 L3
fig. 8
230 V 3
230 V
fig. 9
N
N1-N2
400 V 2N 400V 3N