Monitoring; Maintenance - DSC HS2016 User Manual

Chapter 3.0 The PowerSeries Neo Security System
2. Press [04] or use the scroll keys t o navigate to System Test and
press [*]. The system activates all keypad sounders, bells/sirens
and keypad LEDs for two seconds.
3. To go back to the Ready state press [*].

3.3 Monitoring

This system is capable of transmitting alarms, troubles & emergency information to a central sta-
tion. If you initiate an alarm by mistake, immediately call the central station to prevent an unne-
cessary response.
Note: For CP-01 systems, the monitoring function must be enabled by the installer before it
becomes functional. There is a communicator delay of 30 seconds in this control panel. It can be
removed, or it can be increased up to 45 seconds, at the option of the end-user by consulting with
the installer.

3.4 Maintenance

With normal use, the system requires minimum maintenance. Note the following points:
Do not wash the security equipment with a wet cloth. Light dusting with a slightly
l
moistened cloth should remove normal accumulations of dust.
Use the system test described in "Testing Your System" to check the battery condition.
l
We recommend, however, that the standby batteries be replaced every 3-5 years.
For other system devices such as smoke detectors, passive infrared, ultrasonic or
l
microwave motion detectors or glassbreak detectors, consult the manufacturer's literature
for testing and maintenance instructions.
- 8 -
Press (*) for <>
System Test