Setting Basic System Information; Remotely Setting The System Name And Language - Avaya RADVISION Scopia XT5000 Installation Manual

8. Set the fields as described in
9. From the web interface only, select Save.

Setting Basic System Information

Set the system's basic information, such as the correct local time and date. We recommend modifying
the default administrator PIN to prevent users from modifying advanced settings. For more information,
see the following topics:
Navigation
•

Remotely Setting the System Name and Language

•
Setting the Administrator PIN Code for the XT Server
•
Setting Date and Time
•
Setting the Time Zone
•
Remotely Setting Regional Information
•
Configuring the Screen Saver to Start Automatically
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2
Table 15: Configuring the IP-related call settings
Field Name
DTMF RFC2833 (H.323)
RTP Firewall
Select dialing number format mode
Separator
on page 72
on page 73
Table 15: Configuring the IP-related call settings
DTMF describes a method to send DTMF inside
an audio stream. This method is normally used in
SIP protocol but is uncommon in H.323.
If set to Yes, the H.323 application in the XT
Codec Unit can use DTMF transmission. Verify the
remote endpoint supports RFC2833 before
enabling this field.
If set to Yes, the XT Codec Unit checks the source
of the RTP packets (audio, video, and
presentation) it receives to verify that it matches
the remote endpoint's IP address.
If your XT Codec Unit is not registered with an
H.323 gatekeeper, you can still place a call to an
endpoint registered with a gatekeeper. Check
which format of dialing the gatekeeper accepts and
configure it in this field: <gatekeeper
number><separator> <extension of the called
endpoint>, or <extension> <separator><number>.
The default syntax is
<number><separator><extension>.
Select the field separator accepted by the
gatekeeper. The default separator is ##.
on page 66
on page 71
on page 74
on page 75
on page 66.
Description
Initial Configuration | 66