Heat Sink - HP 355 G2 Maintenance And Service Manual

9. Remove the system board (3) by sliding it up and to the right at an angle.
Reverse this procedure to install the system board.

Heat sink

NOTE: The system board spare part kit includes replacement thermal material.
Description
For use only on computer models equipped with a graphics subsystem with discrete memory
For use only on computer models equipped with a graphics subsystem with UMA memory
Before removing the heat sink, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4. Remove the Battery (see
a. Service cover (see
b. Hard drive (see
c. Optical drive (see
d.
Keyboard (see
e.
Top cover (see
Battery on page 52), and then remove the following components:
Service cover on page
Hard drive on page 54)
Optical drive on page
Keyboard on page 64)
Top cover on page 67)
53)
62)
Component replacement procedures
Spare part number
746658-001
746659-001
87