Source Setup; Source Layout Setting; Setting The Slide Source Change - Alpine INE-W957A Owner's Manual

01GB00INE-W957A.book Page 51 Monday, April 21, 2014 7:49 PM
• HPF (high pass filter): Cuts the lower frequencies and allows the
higher frequencies to pass.
• LPF (low pass filter): Cuts the higher frequencies and allows the
lower frequencies to pass.
• Slope: The level change (in dB) for a frequency change of one octave.
• The higher the slope value, the steeper the slope becomes.
• Adjust the slope to FLAT to bypass the HP or LP filters.
• Do not use a tweeter without the HPF on or set to a low frequency, as
it may cause damage to the speaker due to the low frequency content.
• You cannot adjust the crossover frequency higher than the HPF or
lower than the LPF.
• Adjustment should be made according to the recommended crossover
frequency of the connected speakers. Determine the recommended
crossover frequency of the speakers. Adjusting to a frequency range
outside that recommended may cause damage to the speakers.
For the recommended crossover frequencies of Alpine speakers, refer
to the respective Owner's Manual.
We are not responsible for damage or malfunction of speakers caused
by using the crossover outside the recommended value.
01GB05INE-W957A.fm

Source Setup

Source Layout Setting

The following steps 1 to 5 are common operations to each
"Setting item" of Source Setup. Refer to each section for details.
1
Touch [Setup] icon of Top banner.
The Setup main screen is displayed.
2
Touch [ (Source)].
The Source Setup screen appears.
3
Select the desired item.
Setting items: Source Layout / Disc / AUX / RSE /
BLUETOOTH Pandora (X008AU/INE-W957A only) /
TuneIt
4
Touch [ ] or [ ] etc., to change its setting.
• When the pop-up window for setup is displayed, touch [
close the window after setting.
5
Touch [ ] to return to the previous screen.
• Immediately after changing the Source Setup (while the system is
writing data automatically) do not turn the ignition key to OFF.
Otherwise, the settings may not be changed.
Source Layout Setting
[Source Layout] is selected on the Source setup menu in step 3.
Refer to "Source Layout Setting" (page 51).

Setting the Slide Source Change

You can set whether to switch sources by swiping from the designated
area of the Audio/Visual Playback screen from right to left or from left
to right. Refer to "Switching Sources" (page 28).
Setting item: Slide Source Change
Setting contents: On (Initial setting) / Off
On: Source is changed by a swipe gesture.
Off: Source is not changed by a swipe gesture.
ALPINE INE-W957A 68-24567Z47-A (EN)
] to
51
-EN