Datamax Label Printer Operator's Manual page 28

Char
m Set metric flag, enter metric mode
n Clear metric flag, return to inch mode
O Form edge offset (start of print
position)
o Cycle cutter
P Enter character dump mode
p Controlled pause
Q Clear all memory modules
q Clear module
r Select reflective sensor
S Slew (feed) speed
s Set up for one print buffer
T Printhead dot pattern test label
t Test RAM memory module
(Must be in Test Mode)
U Label format field replacement
V Software switch settings
v Firmware version information
W Request memory module information
w Test FLASH module memory
x Delete module file
X Set default module bank
Y Output sensor values
y Select font symbol set (optional
scalable fonts only)
z Pack module
Z Print internal information and dot
pattern
Table 2-3 System-Level Commands (concluded)
20
Printing Labels
Description Format
All references set to metric until reset
Onnnn = 4 digits, in/100 or mm/10
qx = Module I.D. (Uppercase)
Used for "black-strip" media sensing,
(e.g. continuous tags, butt-cut labels.
Stripe must be printed on back side of
media)
Sx x = A -C (1.0 to 2.0 ips)
Set for 1 dot buffer processing. Use for
full length dot buffer processing.
a bbbK module good
bbb = 256 or 512, for size of module
Vn n = 4-Label Present, 2-Internal
Batch, 1-Cutter Enable
Sends version string to host
Wx x = F-font, G-graphic, L-label
Takes about 90 seconds
xMFname M=Module I.D, F=file type
Xa a - A = Memory Module A
Dumps sensor values status to RS-232
port
y S xx
y = ASCII (0x79)
S = ASCII (0x54)
xx = symbol selection
Zx x= Module I.D
Ovation 2