Removing The Center Control Cover - Dell Studio 1557 Service Manual

Back to Contents Page
Center Control Cover
Dell Studio™ 1557/1558 Service Manual
Removing the Center Control Cover
Replacing the Center Control Cover
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on the back of the computer).
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To help prevent damage to the system board, remove the main battery (see
inside the computer.
Removing the Center Control Cover
1. Follow the instructions in Before You
2. In the battery bay, remove the screw that secures the center control cover.
3. Turn the computer over and open the display as far as possible.
4. Pry out the center control cover with a plastic scribe starting from the battery bay location at the back of the computer.
5. Ease the center control cover up.
1 center control cover
Begin.
Before Working Inside Your Computer) before working