Table of Contents
Advertisement
3. Slide the memory module firmly into the slot at a 45-degree angle, and press the memory module down until it clicks into place. If you do not hear the
click, remove the memory module and reinstall it.
NOTE:
If the memory module is not installed properly, the computer may not boot.
1
tab
CAUTION:
If the base cover is difficult to close, remove the module and reinstall it. Forcing the base cover to close may damage your computer.
4. Replace the base cover (see
5. Slide the battery into the battery bay until it clicks into place, or connect the AC adapter to your computer and an electrical outlet.
6. Turn on the computer.
As the computer boots, it detects the additional memory and automatically updates the system configuration information.
To verify that the memory is installed correctly:
®
Windows Vista
:
Click the Start
® Control Panel® System and Maintenance.
Windows 7:
Click the Start
® Control Panel® System and Security® System.
Back to Contents Page
2
notch
Replacing the Base
Cover).
Advertisement
Table of Contents
