Table of Contents
Advertisement
Back to Contents Page
USB Connector
Dell Studio™ 1557/1558 Service Manual
Removing the USB Connector
Replacing the USB Connector
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on the back of the computer).
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To help prevent damage to the system board, remove the main battery (see
inside the computer.
Removing the USB Connector
1. Follow the instructions in
Before You
2. Remove the optical drive (see
3. Remove the AC adapter connector (see
4. Remove the screw that secures the USB connector.
5. Remove the USB connector cable from the routing guide.
6. Disconnect the USB connector cable from the system board connector.
7. Lift the USB connector and cable out of the computer base.
1
USB connector cable
3
USB connector cable routing
Replacing the USB Connector
1. Follow the instructions in
Before You
2. Place the USB connector and cable in the computer base.
3. Replace the screw that secures the USB connector.
4. Route the USB connector cable through the routing guide.
Begin.
Removing the Optical
Drive).
Removing the AC Adapter
Begin.
Before Working Inside Your
Connector).
2
screw
Computer) before working
Advertisement
Table of Contents
