Folding The Handle; Removing The Mower From Storage - Toro 20068 Operator's Manual

Folding the Handle

Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Remove the ignition key.
2. Loosen the handle knobs until you can move the
upper handle freely.
3. Fold the upper handle forward as shown in Figure 39.
Important: Route the cables to the outside of
the handle knobs as you fold the upper handle.
4. To unfold the handle, reverse the steps above.
Removing the Mower from
Storage
1. Remove the spark plug and spin the engine rapidly
using the starter to blow the excess oil from the
cylinder.
2. Install the spark plug and tighten it with a torque
wrench to 15 ft-lb (20 N⋅m).
3. Charge the battery for 24 hours.
4. Connect the wire to the spark plug.
Figure 39
21