Installing The Blade Control Bar; Unfolding The Handle; Filling The Engine With Oil - Toro 20068 Operator's Manual

Setup
Important: Remove and discard the protective
plastic sheet that covers the engine.
1. Installing the Blade Control
Bar
Procedure
Install the blade control bar into the upper handle
(Figure 3).

2. Unfolding the Handle

Procedure
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Carefully move the upper handle forward until the
handle halves are in line and nest together as shown
(Figure 4).
Figure 3
2. Tighten the handle knobs (Figure 5).
3. Rotate the handle rearward (as shown) until it clicks
into place (Figure 6).

3. Filling the Engine with Oil

Procedure
Your mower does not come with oil in the engine, but it
does come with a bottle of oil.
1. Remove the dipstick (Figure 7).
6
Figure 4
Figure 5
Figure 6