5.
Remove the three Phillips 5.0×2.5 screws in the battery bay, the two Phillips 5.0×2.5 screws
near the hard drive connector, and the nine Phillips 6.0×2.5 screws along the edges of the base
enclosure.
NOTE:
enclosure.
6.
Lift the rear edge of the top cover (1) until the top cover disengages from the base enclosure.
Remove the top cover (2).
NOTE:
Reverse this procedure to install the top cover.
Downloaded from LpManual.com Manuals
The four screws along the front edge also serve to secure the speakers inside the base
The TouchPad is glued to the top cover and is included with the top cover spare part.
Component replacement procedures
57