Advertisement
HOW TO SELECT KILOMETRES AND MILES
The console can display distance and speed in either kilo-
metres or miles. To change the unit of measurement, first
UNPLUG THE POWER CORD. Next, remove the six screws
attaching the console to the console base. Lift the console a
few inches, being careful not to pull on the wires, and turn
the console over. Locate the small switch on the back of the
console. Move the switch upward or downward to select kilo-
metres or miles. Re-attach the console to the console base.
After changing the unit of measurement, remove one of
the batteries from the console for about five seconds
and then reinsert it. This will reset the console.
HOW TO FOLD AND MOVE THE TREADMILL
HOW TO FOLD THE TREADMILL FOR STORAGE
Before folding the treadmill, unplug the power cord.
CAUTION: You must be able to safely lift 20 kg (45 lbs.)
in order to raise, lower, or move the treadmill.
1. Hold the treadmill with your hands in the locations shown
at the right. To decrease the possibility of injury, bend
your legs and keep your back straight. As you raise
the treadmill, make sure to lift with your legs rather
than your back. Raise the treadmill about halfway to the
vertical position.
2. Move your right hand to the position shown at the right,
and hold the treadmill firmly. Raise the treadmill until the
storage latch locks over the frame guide. Make sure that
the storage latch closes fully over the frame guide.
To protect the floor or carpet from damage, place a
mat under the treadmill. Keep the treadmill out of
direct sunlight. Do not leave the treadmill in the stor-
age position in temperatures above 30° C (85° F).
Console
Screws
Console
Base
Screws
Switch
Storage
Closed
Latch
Frame
Guide
10
OPERATION AND ADJUSTMENT
THE PERFORMANT LUBE
TM
WALKING BELT
Your treadmill features a walking belt coated with PERFORMANT LUBE
TANT: Never apply silicone spray or other substances to the walking belt or the walking platform. Such
substances will deteriorate the walking belt and cause excessive wear.
HOW TO PLUG IN THE POWER CORD
This product must be earthed. If it should malfunction or break down,
earthing provides a path of least resistance for electric current to reduce the
risk of electric shock. This product is equipped with a cord having an equip-
ment-earthing conductor and an earthing plug.
Two power cords are included. Select the one that will fit your outlet.
Refer to drawing 1, and plug the indicated end of the power cord into
the socket on the treadmill. Refer to drawing 2. Plug the power cord
into an appropriate outlet that is properly installed and earthed in
accordance with all local codes and ordinances. Note: In Italy, an adap-
tor (not included) must be used between the power cord and the outlet.
Important: The treadmill is not compatible with GFCI-equipped outlets.
DANGER:
Improper connection of the equipment-earthing conductor can result in an
increased risk of electric shock. Check with a qualified electrician or serviceman if you are in doubt
as to whether the product is properly earthed. Do not modify the plug provided with the product—if
it will not fit the outlet, have a proper outlet installed by a qualified electrician.
TM
, a high-performance lubricant. IMPOR-
1
Socket on treadmill
2
Outlet
7
Advertisement
